Omega Vehicle Security OMP-MODL Manual de usuario descargar pdf (Pagina 25)

3... INTERFACE MODULES

USING THE OMP-MODL 3-1

3... INTERFACE MODULES

By adding Interface Modules (Figure 3... -1), the OMP-MODL System Base can be

expanded for additional I/O channels, modem, display, PCMCIA memory, and

battery operation. A full family of modules is available to meet most signal interface

and/or feature requirements.

This section covers the installation, wiring, hardware configuration, and application

considerations of the basic OMP-MODL family of Interface Modules. As additional

modules are added, the instruction sheets should be added to this section for

reference.

Programming and use of added Interface Module channels is done with the

HyperNet Program Net and is covered within Chapter 7 and the Master Icon

Reference in Appendix A.

HANDLING

As with all electronic systems, static electricity discharge can weaken or cause

permanent damage to circuitry. Protective circuitry is integral to the OMP-MODL

system including the Interface Modules, however when the Interface Modules are not

installed in the System Base, the protective circuitry is not effective. Therefore,

when handling Interface Modules, it is recommended that reasonable static control

procedures be followed.

♦ Before touching the Interface Module, discharge static electricity

built up in your body be touching a grounded point such as a

water faucet, cover plate screw on a receptacle, metal surface

of a grounded appliance or other earth ground.

♦ Do not wrap or store the Interface Module in static generating

materials such as untreated styrofoam packing `peanuts’ or

Inter-Module Connection bus

I/O Wiring Terminal

Strip

Side Retaining Screw holes

Figure 3... -1: Interface Module

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 296 297

Sin comentarios

Omega Vehicle Security OMP-MODL Manual de usuario Pagina 25