Omega Vehicle Security TCIC Manual de usuario descargar pdf (Pagina 35)

TCIC User’s Manual

One Card System

When a system includes only one card, neither configuration nor

selection is required, as the card is factory defaulted to address ‘a’.

Indeed, if a card has been configured to some non-‘a’ address and

later it is required as a single card, you may re-configure it to

address ‘a’, eliminating the need for the selection function in your

application. This is the only case that a card is configured to

address ‘a’.

Configuring a Card Address

Configuring a card address is carried out by the TCIC-Monitor

utility:

• Connect the card to be configured to the USB port.

• In the TCIC-Monitor utility click Setup/Card Address and

choose the required address. Be sure to choose a free

and non-‘a’ address; that is, an address that no other

card is configured to, but not ‘a’.

• Exit the TCIC-Monitor utility.

The card is now ready to be wired into an RS485 network.

When it is powered on, it will not be selected until a

selection command with the correct address is sent by the

application.

It is the

user’s responsibility

to make sure that each

card is configured to a unique, non-‘a’, address.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 43 44

Sin comentarios

Omega Vehicle Security TCIC Manual de usuario Pagina 35